Difference between revisions of "User:Meklort/SORDIMM"
| (One intermediate revision by the same user not shown) | |||
| Line 9: | Line 9: | ||
After contacting a number of vendors, I received a response from Viking Technology where they were willing to send 10x 16GB, 2666MHz SORDIMM to Digikey so that I could purchase a few sticks: https://www.digikey.com/products/en?keywords=VR9FR2G7228JBKSBD4 | After contacting a number of vendors, I received a response from Viking Technology where they were willing to send 10x 16GB, 2666MHz SORDIMM to Digikey so that I could purchase a few sticks: https://www.digikey.com/products/en?keywords=VR9FR2G7228JBKSBD4 | ||
| + | |||
Datasheet: https://media.digikey.com/pdf/Data%20Sheets/Viking%20PDFs/PS9FRxx72x8xxx_Rev.E_3_7_2018_DS.pdf | Datasheet: https://media.digikey.com/pdf/Data%20Sheets/Viking%20PDFs/PS9FRxx72x8xxx_Rev.E_3_7_2018_DS.pdf | ||
| Line 20: | Line 21: | ||
| − | Additionally, the Talos II firmware (as of 1.07) was unable to properly | + | Additionally, the Talos II firmware (as of 1.07) was unable to properly detect the manufacturer ID from the modules. As a quick test, I modified the hostboot firmware to treat a manufacturer id of 0 as Samsung. Once done, the RAM was detected and booted without issues. |
Latest revision as of 20:59, 9 December 2018
Enabling SO-DOMM modules on the Talos II
The Talos II supports a large number of full sized DIMMs, however, in order to check the feasibility of a smaller form factor (read: laptop), the hardware and firmware need to be able to support SO-DIMMs.
Hardware Requirements
The Sofra POWER9 CPU requires registered DDR4 RAM with EC. This is relatively easy to find in the full-sized form factor, however it becomes a bit harder to find in the SO-DIMM form factor. In this case, we actually need to use SORDIMMs (note the extra R for registered).
After contacting a number of vendors, I received a response from Viking Technology where they were willing to send 10x 16GB, 2666MHz SORDIMM to Digikey so that I could purchase a few sticks: https://www.digikey.com/products/en?keywords=VR9FR2G7228JBKSBD4
Datasheet: https://media.digikey.com/pdf/Data%20Sheets/Viking%20PDFs/PS9FRxx72x8xxx_Rev.E_3_7_2018_DS.pdf
In order to adapt the above modules to the full sized slot, something like the following can be used: https://www.amazon.com/gp/product/B07DMNH15W/ref=oh_aui_search_detailpage?ie=UTF8&psc=1
Software Requirements
Before SORDIMM modules can be used, a couple of minor patches to the hostboot firmware must be made. The first patch is simply enabling hostboot to recognize that SORDIMM modules are valid.
File:0001-Update-hostboot-to-allow-DDR4-SORDIMM-modules-to-be- (1).patch
Additionally, the Talos II firmware (as of 1.07) was unable to properly detect the manufacturer ID from the modules. As a quick test, I modified the hostboot firmware to treat a manufacturer id of 0 as Samsung. Once done, the RAM was detected and booted without issues.
