Difference between revisions of "Firmware Upstreaming"
Jump to navigation
Jump to search
(→HCODE) |
(→OCC) |
||
| Line 22: | Line 22: | ||
=== OCC === | === OCC === | ||
| − | * remove prebuilt GPU1 binary | + | same for Blackbird and Talos |
| + | * remove prebuilt GPU1 binary - not required for upstream | ||
| + | * Fix build failure on GCC8 | ||
| + | |||
=== skiboot === | === skiboot === | ||
=== op-build === | === op-build === | ||
Revision as of 14:36, 17 December 2019
This page should cover firmware upstreaming for Talos and other RaptorCS systems. Because it would be very useful to be able to build new firmware directly from upstream sources.
Contents
Host firmware
working with the 04-16-2019 branch, which is in the v2 firmware
SBE
same for Blackbird and Talos
- Send IPL status codes to BMC over LPC port 81h/82h = https://github.com/open-power/sbe/pull/15
- Disable SBE console print as it significantly slows down SBE execution
HCODE
same for Blackbird and Talos
- Update ring files from hostboot-binaries
- Allow split of HOST and TARGET toolchain binary names - useful, but likely not required
- Revert "Self Save: Added support for SPR self save in CME hcode(func ver)" - should be superceeded by a real fix in https://github.com/open-power/hcode/commit/cc0b781abd67673240c208df7c77d2d37906057f
-> no changes needed
Hostboot
same for Blackbird and Talos
- cap voltage offset when biased
- Add detailed ISTEP output option to hostboot
- Don't try to add proprietary CAPP microcode image to PNOR (could be skipped in upstream)
OCC
same for Blackbird and Talos
- remove prebuilt GPU1 binary - not required for upstream
- Fix build failure on GCC8
skiboot
op-build
- skiroot kernel config changes
